INGEMAQ

Mechanical engineering firm

Design and verification of lifting equipment and storage tanks

We prepare calculation reports for lifting devices and storage tanks, with code-based verification and finite element models where the code alone is not enough.

ASME BTH-1ASME B30.20AWS D14.1API 650AWWA D100CIRSOC / INPRES
3D model of a vertical cylindrical tank with a cone roof and perimeter handrail
Calculation model of a storage tank

Services

Every job is delivered with a traceable calculation report — design data, assumptions, checks and conclusions — ready for fabrication, client submission or audit.

Lifting device verification

We verify below-the-hook lifting devices: C-hooks, lifting beams and spreader beams, lifting lugs and custom-designed attachments, for coils, plates, equipment and structures.

Scope

  • Design category and service class selection to ASME BTH-1.
  • Member checks for bending, shear and combined stresses.
  • Pinned connections: double shear, net tension and bearing.
  • Welds to ASME BTH-1 and AWS D14.1.
  • Fatigue based on the number of load cycles expected over the service life.
  • Finite element analysis (FEA) for areas not covered by the code, with model validation and mesh convergence.

Reference standards

ASME BTH-1, ASME B30.20, AWS D14.1, ASTM A36 / A572.

Geometry of a C-hook lifting device
Model geometry
Von Mises equivalent stress in a C-hook
Equivalent stress
Safety factor map of a C-hook
Safety factor
Stress detail at a welded joint
Weld detail

Storage tank design

We design and verify welded steel vertical cylindrical tanks, new or existing, for hydrocarbons, water and other process fluids.

Scope

  • Shell, roof and bottom plate thicknesses.
  • Self-supported or supported cone roofs and stiffening rings.
  • Wind and seismic loads to Argentine CIRSOC and INPRES-CIRSOC 103 regulations.
  • Overturning stability and anchorage.
  • Nozzles and external loads on connections.
  • Venting to API 2000.
  • Associated structures: agitator bridges, platforms and access, to AISC 360.

Reference standards

API 650 (tanks for oil and petroleum products), AWWA D100 (water storage tanks), API 2000, AISC 360, CIRSOC 101 / 102 / 104, INPRES-CIRSOC 103.

Structural model of an agitator support bridge on a tank
Structural model of an agitator bridge

How we work

A structured process, with one technical lead from start to finish.

Data gathering

Drawings, specifications, service conditions and applicable standards.

Calculation

Code-based checks and, where needed, finite element models.

Calculation report

A document with input data, assumptions, results and conclusions.

Follow-up

Replies to client comments and revisions through to approval.

Tools: ANSYS, Smartank, STAAD.Pro, Mathcad and 3D CAD modelling.

Contact

Send us the drawings or a description of the equipment and we will reply with the scope and a quote.

Send an email Message us on WhatsApp

Emailinfo@ingemaq.com.ar

WhatsApp+54 9 11 6948-6320

LocationSan Martín, Buenos Aires, Argentina